-
961
Management of a traumatic avulsion fracture of the occipital condyle in polytrauma patient in Korea: a case report
Published 2023-06-01“…On her computed tomography angiography, the displaced occipital condyle compressed on the sigmoid sinus resulting in its obstruction. …”
Get full text
Article -
962
Innovative use of stabilized pond ash as a sustainable material for flexible pavements: Experimental, microstructural, and numerical investigations
Published 2025-07-01“…The findings also underscore the environmental and economic benefits of utilizing treated pond ash, offering a cost-effective and eco-friendly alternative to natural aggregates. …”
Get full text
Article -
963
Studies on mechanical properties characterization of hybrid sisal and stinging nettle fiber reinforced epoxy composite material
Published 2025-07-01“…The densities of the treated fibers were measured using the pycnometer method. …”
Get full text
Article -
964
Preparation and mechanical characterization of pressed carbonized wood sawdust bio-composite
Published 2025-04-01“…Compressive strength tests revealed that cement-based composites with water-treated sawdust and 20% sand achieved a 44% strength increase (up to 9.6 MPa), while 30% cement replacement with shale ash yielded a 55% strength gain and improved water resistance (softening coefficient: 0.55). …”
Get full text
Article -
965
Study on the Effect of High-Temperature Heat Treatment on the Microscopic Pore Structure and Mechanical Properties of Tight Sandstone
Published 2021-01-01“…The variations of wave velocity, permeability, tensile strength, uniaxial compressive strength, and microscopic pore structure of the core samples were analyzed. …”
Get full text
Article -
966
Facelift light, rhytidoplasty for the treatment of the face and neck lower third with reduced scarring and adhesion points
Published 2020-09-01“…Introduction: Facelift light represents a technique standardization to treat face and neck lower third, with lesser scars, SMAS plication in all patients, and adhesion points to reduce bruises. …”
Get full text
Article -
967
Effect of ultrasonic surface rolling processing on surface integrity and mechanical properties of ZL205A alloy
Published 2025-07-01“…This study investigates the effects of ultrasonic surface rolling process (USRP) parameters—static pressure, feed speed, ultrasonic amplitude, and rolling passes—on the surface integrity, mechanical properties, and microstructural evolution of T6 heat-treated ZL205A Al–Cu alloy. Comprehensive characterization demonstrates that USRP treatment significantly enhances surface quality, producing an ultra-smooth surface with a minimum roughness (Ra) of 0.08 μm while simultaneously increasing surface microhardness to 168.10 HV and introducing compressive residual stresses of −128.3 MPa. …”
Get full text
Article -
968
Ovarian Mass Causing Paradoxical MI and Leg Ischaemia
Published 2012-01-01“…During percutaneous coronary intervention to treat this occlusion the thrombus became lodged at the aortic bifurcation causing lower limb ischaemia. …”
Get full text
Article -
969
Impact of Temperature and Humidity on Key Mechanical Properties of Corrugated Board
Published 2024-12-01“…This research explores how temperature and relative humidity impact the mechanical properties of corrugated cardboard. Samples were treated under a range of controlled climate conditions in a climate chamber to simulate varying environmental exposures. …”
Get full text
Article -
970
Reinforcement Mechanism and Engineering Application of Weak Tailing Pond Beach by Soilbag Method
Published 2022-01-01“…In light of the engineering characteristics of fine-grained tailings, such as their high moisture content, high compressibility, difficult deposition, and difficult consolidation, and based on the summary and analysis of the experience of tailing dam construction in China and abroad, a new comprehensive treatment technology suitable for dam construction on a weak beach, which is composed of strengthening foundation with the soilbag, subdam stabilization, and collaborative drainage, is proposed. …”
Get full text
Article -
971
Preparation of geopolymer membranes using clay and some industrial wastes to remove the organic load of pharmaceutical wastewater
Published 2025-05-01“…The porosity decreased significantly due to waste additions, the decrease in porosity led to a decrease in water flow, while the compressive strength of the membranes increased with the effect of waste addition. …”
Get full text
Article -
972
Influence Mechanism of Accelerator on the Hydration and Microstructural Properties of Portland Cement
Published 2024-10-01“…After 28 days of curing, EDS analysis indicates an average Ca/Si ratio of 1.171 for the AKF-treated shotcrete; the average Ca/Si ratio shows minimal variation from the reference group and is classified as the same type of C-S-H gel as the reference group. …”
Get full text
Article -
973
Preparation of Nano-SiO2/Carbon Fiber-Reinforced Concrete and Its Influence on the Performance of Oil Well Cement
Published 2019-01-01“…., secondary channeling), the preparation of nano-SiO2/carbon fiber-reinforced body and its influence on the performance of oil well cement were studied to improve the cement stone and enhance its adaptability to oil well pressure in this study. Carbon fibers were treated by liquid phase oxidation and a coupling agent, and the “grafting to” was used to bond nano-SiO2 and carbon fibers. …”
Get full text
Article -
974
Global–Local Query-Support Cross-Attention for Few-Shot Semantic Segmentation
Published 2024-09-01“…However, the majority of existing FSS methods either compressed support features into several prototype vectors or constructed pixel-wise support-query correlations to guide the segmentation, which failed in effectively utilizing the support information from the global–local perspective. …”
Get full text
Article -
975
Strength and Road Performance of Superabsorbent Polymer Combined with Cement for Reinforcement of Excavated Soil
Published 2021-01-01“…Laboratory experiments were performed to determine unconfined compressive strength (UCS), compactness, durability after wetting and drying cycles, drying shrinkage, and California bearing ratio (CBR). …”
Get full text
Article -
976
Experimental Evaluation of Sodium Silicate-Based Nanosilica against Chloride Effects in Offshore Concrete
Published 2014-01-01“…Each particle of SS is chemically treated to have the negative (−) charge on its surface. …”
Get full text
Article -
977
Mechanisms of laser non-uniform shock peening on the mechanical properties of SUS 304 stainless steel weld joints
Published 2024-11-01“…The results indicate that LNUSP induced residual compressive stress with an affected layer depth exceeding 0.9 mm, leading to a more uniform residual stress distribution. …”
Get full text
Article -
978
Mechanical Behavior of Plastic Strips-Reinforced Expansive Soils Stabilized with Waste Marble Dust
Published 2022-01-01“…With the addition of marble dust, unconfined compressive strength (UCS) values increase linearly, while they increase only up to 0.5% with the addition of plastic strips. …”
Get full text
Article -
979
A simple and universal strategy for preparing external stress-free two-way shape memory polymers by making use of the chemical crosslinkages derived from peroxide initiator
Published 2020-04-01“…Having been stretched and heat treated without additional ingredients and chemicals, the trained PU showed the desired two-way shape memory effect. …”
Get full text
Article -
980
Engineering Performance and Mechanism of Alkali-Activated Ground Granulated Blast Furnace Slag–Zeolite Powder Grouting Materials
Published 2025-03-01“…Compared to existing commercial grouting materials, the compressive strength of this new grout is comparable to that of silty mudstone. …”
Get full text
Article