-
4761
Evaluating Material Parameter Influence on Drapability Using VStitcher
Published 2025-01-01“…A drape test is used as a validation method and the drape coefficient is calculated. Depending on the material and parameter settings, drape coefficients between 0.1 and 10% and between 0.7 and 70% are determined. …”
Get full text
Article -
4762
SURFACE OSCILLATIONS IN OPEN RESONATORS WITH CURVILINEAR REFLECTORS
Published 2025-03-01“…The electric field structures of considered oscillation types were measured using the probe-induced perturbation method. The resonant transmission coefficients of the open oscillating systems and the physical phenomena within them were experimentally studied with the aid of well-known microwave measurement techniques. …”
Get full text
Article -
4763
Modeling creep for a closed cylindrical shell under hydrostatic pressure
Published 2025-01-01Get full text
Article -
4764
Quantitative Study of Spodumene by Time-of-Flight Secondary Ion Mass Spectrometry (tof-SIMS)
Published 2025-03-01“…Thus, the matrix-matched standard calibration method for element determination of spodumene by tof-SIMS was recommended. …”
Get full text
Article -
4765
Predicting Water Distribution and Optimizing Irrigation Management in Turfgrass Rootzones Using HYDRUS-2D
Published 2025-03-01“…Data were collected under controlled greenhouse conditions across unvegetated plots with two- and three-layered rootzone construction methods, each receiving 10 mm of water (intensity of 10 mm h<sup>−1</sup>) via subsurface drip irrigation (SDI) or a sprinkler (SPR). …”
Get full text
Article -
4766
Study on Semi-Rigid Joint Performance and Stability Bearing Capacity of Disc-Type Steel Pipe Support
Published 2025-06-01“…Numerical simulation and analytical correction method were employed to determine the effective length correction coefficient <inline-formula><math xmlns="http://www.w3.org/1998/Math/MathML" display="inline"><semantics><mrow><msub><mrow><mi mathvariant="sans-serif">μ</mi></mrow><mrow><mn>0</mn></mrow></msub></mrow></semantics></math></inline-formula> under various erection parameters while accounting for joint semi-rigidity. …”
Get full text
Article -
4767
Flash glucose monitoring system help reduce the frequency of hypoglycemia and hypoglycemic fear behavior in type 1 diabetes patients
Published 2024-11-01“…The optimal cut-off point for GCV was determined to be 40.55.…”
Get full text
Article -
4768
Helminth contamination of Wild Ruminants in the West kazakhstan Region and activity of the supramolecular complex of albendazole with Polyvinylpyrrolidone at helminthoses
Published 2020-06-01“…Materials and methods. Incomplete helminthological autopsy according to K. …”
Get full text
Article -
4769
Experimental Estimation of Two-Phase Flow Parameters in the Pneumatic System of a Sowing Complex
Published 2025-01-01“…Both the possibility of implementing models with computational methods and the complexity of the models used depend on the intensity of interphase interaction. …”
Get full text
Article -
4770
Analysis of energy costs for shunting operations performed by electric locomotives
Published 2024-12-01“…The discussion of the use of such locomotives should take into account the power consumption figures achieved by mainline electric locomotives of the existing series in shunting operations.Materials and Methods. The paper uses statistical methods to analyse power consumption on driver’s routes for 2023 and processes registered on-board data of electric locomotives involved in shunting operations for individual driver’s shifts. …”
Get full text
Article -
4771
Adaptive Neuro-Fuzzy Inference System-Genetic Algorithm approach for global maximum power point tracking in PV systems under different shading conditions
Published 2025-10-01“…The proposed ANFIS-GA method, simulated with MATLAB/Simulink, was evaluated in three environments, i.e., no shading, partial shading, and severe shading, and performances were 99.98%, 98.5%, and 97.67% (GMPPT efficiencies), respectively. …”
Get full text
Article -
4772
Finite-element analysis of contact characteristics and friction modes of the "valve-guide" of the internal combustion engine
Published 2024-09-01“…Based on the constructed finite-element model of the "valve-guide" conjugation, an analysis of the influence of determining tribological factors: sliding speed in contact, temperature, skew angle, friction coefficient on contact stresses both for each part of the friction pair and in the process of contact interaction was carried out. …”
Get full text
Article -
4773
Experimental Investigation of the Influence of Climatic Conditions and Vehicle Dynamics on the Thermal Management System of a Fuel Cell Electric Vehicle
Published 2025-06-01“…However, at the stack level, balance of plant (BoP) components demonstrate the ability to ensure ambient temperature-independent performance, likely due to reliable humidification control up to 45 °C. Additionally, a new method for determining thermal derating of FCEVs on roller dynamometer tests is presented. …”
Get full text
Article -
4774
Green Economy and a New Approach to Its Measurement
Published 2022-09-01“…The purpose of the study is to propose a model for a comparative assessment of the degree of «greenness» of the economy of each country, to identify weak determinants to increase the degree of «greenness» of the countries included in this model, as well as to scientifically substantiate possible ways of developing weak determinants. …”
Get full text
Article -
4775
ANALISIS PENDAPATAN USAHATANI PADA KOPI TRADISIONAL DAN KOPI SAMBUNG DI DESA LUBUK KEMBANG, KEC. CURUP UTARA, KAB. REJANG LEBONG
Published 2012-03-01“…The purpose of this study are: 1) to calculate revenue on the traditional coffee farming and grafting coffee farming and 2) to determine the condition of efficiency in traditional coffee farming and grafting coffee farming and their difference. …”
Get full text
Article -
4776
Prediction and Analysis of Rice Production and Yields Using Ensemble Learning Techniques
Published 2024-08-01“…For instance, the ensemble model for predicting area harvested, combining Model 6 (linear regression) and Model 10 (ARIMA), achieved of coefficient of determination outperforming the individual models. …”
Get full text
Article -
4777
Optimized Artificial Neural network models to time series
Published 2022-08-01“…It is one of the problems that can bias the test of the robustness of the ANN in time series forecasting. To determine the best or the optimal ANN models, forecast Skill (SS) employed to measure the efficiency of the performance of ANN models. …”
Get full text
Article -
4778
Modeling the performance indicators of geotechnological blocks and the movement of the discovered reserves of an underground borehole leaching of uranium
Published 2020-08-01“…This work conducts a comprehensive analysis of system relationships between the main technical and technological indicators of technological blocks functioning at underground uranium leaching mines. Methods. An information model describing the operation of technological wells was created. …”
Get full text
Article -
4779
-
4780
Nature-based solutions as an economical option for the removal of micropollutants in artificial wastewater: the case of a laboratory constructed wetland planted with Phragmites aus...
Published 2025-03-01“…This study adopted the method of hydrological balance proposed by Kadlec and Wallace for the construction of a combination of Horizontal Subsurface Flow Constructed Wetlands and Vertical Subsurface Flow Constructed Wetlands planted with Phragmites australis to investigate micropollutants load removal as well as the treatment efficiency of lab constructed wetlands. …”
Get full text
Article