-
241
Modeling and Evaluation of Mutual Coupling Effect in Conventional Switched Reluctance Machines Using Space Vector Representation
Published 2022-01-01“…The proposed method is compared with a conventional model where the mutual coupling is not considered. …”
Get full text
Article -
242
Real-Time Modeling of Static, Dynamic and Mixed Eccentricity in Permanent Magnet Synchronous Machines
Published 2025-02-01Get full text
Article -
243
-
244
Design, Analysis, and Comparison of Electric Vehicle Electric Oil Pump Motor Rotors Using Ferrite Magnet
Published 2025-01-01“…Finite element analysis (FEA) was used to compare the performance of these models with that of the basic rotor design, considering factors such as the no-load back electromotive force, no-load voltage harmonics (<10%), cogging torque (<0.1 Nm), load torque, motor loss, and efficiency (>80%). …”
Get full text
Article -
245
The Analysis of Permanent Magnet Synchronous Generator No-load Voltage Sine Distortion Rate
Published 2018-06-01“…To obtain corresponding conclusions, the no-loading EMF and the air gap flux density and cogging torque, which are respectively in the case of non-uniformity air-gap and uniform air-gap, are compared by the way of finite element; in the same time, put forward a 2D segmentation method to solve the 3D issue. …”
Get full text
Article -
246
Parameter Optimisation of a H-type Three-blade Contra-rotating Vertical-axis Wind Turbine at Low Tip-speed Ratio
Published 2025-03-01“…The optimum CR-VAWT was derived, and its power coefficients were compared with those of a stand-alone VAWT under low tip-speed ratio (TSR). …”
Get full text
Article -
247
永磁联轴器传动力矩的一种新算法
Published 2004-01-01“…Various methods such as experiential, finite element and analytical methods are introduced and compared. …”
Get full text
Article -
248
Does High Medial Elbow Stress During Pitching Compromise the Dynamic Stabilizers of The Elbow?
Published 2023-08-01“…Elbow valgus torque was measured from an inertial measurement unit, housed in a compression sleeve and pitchers were categorized as having high or low valgus torque…”
Get full text
Article -
249
Optimization of an Asymmetric-Rotor Permanent Magnet-Assisted Synchronous Reluctance Motor for Improved Anti-Demagnetization Performance
Published 2024-12-01“…The rotor structure of the proposed model is globally optimized by combining the two methods. Anti-demagnetization performance is improved as much as possible under the premise of ensuring the torque performance of the basic model. …”
Get full text
Article -
250
Effect of Thermodynamic Cyclic Loading on Screw Loosening of Tightened Versus New Abutment Screw in Bone Level and Tissue Level Implants in DIO Implant Company (In‐Vitro Study)
Published 2025-08-01“…New screws showed less torque reduction compared to previously tightened screws. …”
Get full text
Article -
251
Comparison of Common Methodologies for the Determination of Knee Flexor Muscle Strength
Published 2021-04-01“…The validity and test-retest reliability of eccentric knee flexor strength on the NordBord hamstring dynamometer was assessed and compared with isometric strength on the BD. # Results Level of agreement between HHD and BD torque demonstrated low bias (bias -0.33 Nm, SD of bias 13.5 Nm; 95% LOA 26.13 Nm, -26.79 Nm). …”
Get full text
Article -
252
Biomechanical Basis of Interval Throwing Programs for Baseball Pitchers: A Systematic Review
Published 2023-10-01“…A secondary purpose was to examine the kinematics produced during interval throwing compared to those seen during baseball pitching. # Study Design Systematic Review # Methods Following PRISMA guidelines, PubMed, Embase, Web of Science, SPORTDiscus, and Google Scholar were systematically searched for biomechanical studies of flat-ground throwing and partial-effort pitching in baseball between 1987 and 2023. …”
Get full text
Article -
253
Study on Step Skewing of Rotor for Permanent Magnet Synchronous Motor
Published 2012-01-01“…It presents a calculation method of best step skewing angle. Based on finite element analysis, no-load EMF, cogging torque and load torque of a prototype motor with different step numbers are calculated and compared, the principle of choosing step numbers is then obtained. …”
Get full text
Article -
254
Effect of low-intensity resistance training at different levels of blood flow restriction on pain, proprioception and muscle strength in patients with knee osteoarthritis: a random...
Published 2025-08-01“…The LIRT + BFR80% group demonstrated lower AE values of 60 ° knee flexion and higher peak torque, average peak torque, and average power at 60°/s after intervention compared to the LIRT + BFR30% and LIRT + BFR50% groups (P < 0.05). …”
Get full text
Article -
255
Effectiveness Evaluation of Penetration-Detection Scheme for Surgical Drill Using Thrust Force and Positional Information
Published 2025-01-01“…The theoretical model indicates that the thrust force reacts more sensitively than the torque at penetration. The detection methods using the force-based and torque-based methods were compared through experiments. …”
Get full text
Article -
256
Comparison of the effects of kilohertz- and low-frequency electric stimulations: A systematic review with meta-analysis.
Published 2018-01-01“…KFAC did not significantly increase muscle-evoked torque, compared to PC (pooled SMD: -0.25; 95% CI: -0.53, 0.06; P = 0.120). …”
Get full text
Article -
257
The Effects Of Differing Density Of Swim-Training Sessions On Shoulder Range Of Motion and Isometric Force Production In National and University Level Swimmers
Published 2023-04-01“…Greater drops in rotation torque were found in university swimmers (IR change= -15% to -21.0%; d= 0.83-1.66; ER change= -9.0% to -17.0%; d= 1.14-1.28) compared to national swimmers (IR change= -10.0% to -13.0%; d= 0.61-0.91; ER change= -3.7% to -9.1%; d= 0.50-0.96). …”
Get full text
Article -
258
Proprioception and Central Nervous Excitability: Implications for Return-to-Play in Athletes with Ligament or Meniscal Injuries
Published 2025-08-01“…Torque maintenance was assessed under two conditions: visual feedback and verbal instructions. …”
Get full text
Article -
259
Modification of a Two-Part Cancellous Locking Screw: A Pilot Study on Increasing Resistance to Axial Pullout Strength
Published 2025-04-01“…This study aimed to test the hypothesized advantages of TP-LCS over LSs. <b>Methods:</b> An MTS 370 series frame with an axial/torsional load cell was used to test driving torque and axial pullout strength, following ASTM F543-07 standards. …”
Get full text
Article -
260
Effect of different agents on preload force of dental implants with bio high-performance poly-ether-ether-ketone abutments
Published 2024-11-01“…In the other three groups, blood (B), normal saline (N) and saliva (S) was added in the access cavity of the samples. A sequential torque of 15 Ncm, 20 Ncm, 25 Ncm, 30 Ncm up to 35 Ncm was applied with a digital torque meter (Eclatorq, model: SD-05bn, range:2.5–50 Ncm, torque accuracy: ± 2%cw). …”
Get full text
Article