-
2421
Effect of Different Cooking Methods on Quality of Salted Egg Yolk
Published 2025-05-01“…This study elucidated the effects of different cooking methods on the macroscopic characteristics of SEY from a microstructural perspective and provided valuable data support for further research on its cooking techniques.…”
Get full text
Article -
2422
Hot-dip aluminizing of stainless steel and investigation of interfacial intermetallics
Published 2025-05-01“…The types and evolution of Fe–Al intermetallic compounds (IMCs) serve as the theoretical foundation for regulating the microstructure and properties of the aluminum/steel joining interface. …”
Get full text
Article -
2423
Research on the Improvement of Wear Resistance of Si<sub>3</sub>N<sub>4</sub> Substrate by Magnetron Sputtering Deposition of TiN Thin Films with Different Film Structures
Published 2025-07-01“…In order to solve the problem that the surface of silicon nitride ceramic bearings is susceptible to wear under extreme operating conditions,gradient,multilayer and monolayer TiN films were prepared on silicon nitride substrates using magnetron sputtering.Three nitrogen supply modes were implemented: a gradual increase starting at 15 mL/min with 0.8 mL/min increments every 5 min,an alternating on-off switching between 0 and 30 mL/min,and a constant 30 mL/min flow.The influence of film structure on surface morphology,cross-sectional morphology and microstructure was investigated using X-ray diffractometer (XRD) and scanning electron microscopy (SEM),while the filmsubstrate adhesion and tribological properties were evaluated through scratch and friction-wear tests.Results showed that under identical testing conditions,the gradient TiN film exhibited the highest film-substrate adhesion strength (LC2 =19.12 N),representing an approximately 30%improvement compared to the monolayer TiN film.Compared to silicon nitride’s friction coefficient (0.78) and wear rate [1.51×10-5 mm3/(m·N)],both the friction coefficients and wear rates of TiN films with different film structures significantly decreased.Among them,the gradient TiN film exhibited the lowest friction coefficient (0.10) and the lowest wear rate [3.33×10-6 mm3/(m·N)].Different film structure designs significantly influenced the microstructure,film-substrate adhesion and tribological properties of TiN coatings.The film with the best tribological properties was a gradient TiN film structure.…”
Get full text
Article -
2424
In vivo Confocal Microscopy for Corneal and Ocular Surface Pathologies: A Comprehensive Review
Published 2025-06-01“…Arturo Ramirez-Miranda,1 Jesus Guerrero-Becerril,1 Manuel Ramirez,2 Guillermo Raul Vera-Duarte,1 Simran Mangwani-Mordani,1,3,4 Gustavo Ortiz-Morales,1 Alejandro Navas,1 Enrique O Graue-Hernandez,1 Jorge L Alio5 1Departamento de Córnea y Cirugía Refractiva, Instituto de Oftalmología Fundación Conde de Valenciana IAP, Mexico City, Mexico; 2Departamento de Córnea y Cirugía Refractiva, Asociación para Evitar la Ceguera en México, Hospital Luis Sánchez Bulnes, Universidad Nacional Autónoma de México, Mexico City, Mexico; 3Surgical Services, Department of Ophthalmology, Miami Veterans Affairs Medical Center, Miami, FL, USA; 4Department of Ophthalmology, Bascom Palmer Eye Institute, University of Miami, Miami, FL, USA; 5Research and Development Department, VISSUM Miranza, Alicante, SpainCorrespondence: Arturo Ramirez-Miranda, Instituto de Oftalmologia Fundacion Conde de Valenciana IAP, Chimalpopoca 14, Centro, Cuauhtémoc, Ciudad de México, CDMX, CP 06800, Mexico, Email arturorammir@gmail.comBackground: In vivo confocal microscopy (IVCM) is an advanced imaging technique that enables real-time, high-resolution visualization of corneal microstructures. Its clinical applications have expanded significantly, offering valuable insights into the pathophysiology of various ocular surface and corneal disorders. …”
Get full text
Article -
2425
Chloride Transport in OPC Concrete Subjected to the Freeze and Thaw Damage
Published 2017-01-01“…To predict the durability of a concrete structure under the coupling degradation consisting of the frosting and chloride attack, microstructural analysis of the concrete pore structure should be accompanied. …”
Get full text
Article -
2426
Application of Rosa roxburghii Tratt. extraction in improving gel properties and flavour of hairtail (Trichiurus lepturus) surimi
Published 2025-03-01“…The results of water migration and protein secondary structure analysis showed that RRTE could effectively stabilise the internal water distribution of hairtail surimi gels and inhibit protein denaturation. Microstructural observation showed that the gel structure of hairtail surimi in the RRTE added group was more uniform and dense, and the fractal dimension was reduced. …”
Get full text
Article -
2427
In situ diffraction study on the annealing performance of a rapidly solidified ribbon consolidated Mg-Ca-Y-Zn-Mn alloy
Published 2025-04-01“…On the basis of XRD results, the stages of the microstructure evolution during heating were identified. …”
Get full text
Article -
2428
Ex vivo study of Porcine esophagus magnetic resonance imaging with a compact endoluminal coil
Published 2025-06-01“…These findings demonstrate that Endo-MR offers high spatial resolution and stable image quality, enabling detailed visualization of fine esophageal microstructures and small lesions, thus holding promising potential for clinical diagnosis.…”
Get full text
Article -
2429
Effect of the Concentration of a Nitrite-Based Inhibitor and Chloride Ions on the Corrosion Behavior of FCD-500 in a Simulated Marine Engine Cooling Water System
Published 2025-05-01“…Immersion and electrochemical tests were performed to analyze the microstructural corrosion characteristics and inhibitor efficiency. …”
Get full text
Article -
2430
Surface engineering for enhanced wicking: The role of laser machining and surface roughness
Published 2024-12-01“…This study provides insights into how laser machining influences wicking dynamics in microstructures, offering strategies for optimizing microfluidic devices.…”
Get full text
Article -
2431
Strain rate sensitivity of TC4 alloy sheet under electrically-assisted tension: Mechanical responses and electroplastic mechanisms
Published 2025-09-01“…Dynamic strain aging (DSA), electrically-induced dynamic recrystallization (DRX), slight α→β phase transformation and grain boundary deformation coordination under “hot spots” and charge imbalance effects are the featured microstructure evolution phenomena in quasi-static EA tension. …”
Get full text
Article -
2432
Exploring thoracic aorta ECM alterations in Marfan syndrome: insights into aorta wall structure
Published 2025-07-01“…This study investigated microstructural and molecular alterations in the thoracic aorta of Fbn1mgΔlpn mice, with a focus on the tunica intima and media. …”
Get full text
Article -
2433
Characterization of Oxygen Diffusion and Catalytic Behavior of Composite Materials in Solid Oxide Fuel Cells Using the Non-destructive Adler-Lane-Steele Method
Published 2024-11-01“…Understanding the fundamental properties of oxygen self-diffusion in solid-state ionic systems is critical for developing nextgeneration electrolyte and electrode material compositions and microstructures that enable SOFCs to operate at lower temperatures more effectively, durably, and affordably. …”
Get full text
Article -
2434
Investigation of Wear Behaviour and Mechanical Properties of Titanium Diboride Reinforced AMMC Composites
Published 2022-01-01“…The prepared composites are evaluated by wear analysis, tensile properties, hardness range, and microstructural behavior studies. …”
Get full text
Article -
2435
Early new bone formation in ovine intramuscular defects: comparison between different silicate-containing calcium phosphate synthetic bone grafts
Published 2025-04-01“…The bone graft with a micron-scale microstructure and low surface area (micro-Si-CaP) exhibited very limited evidence of new bone formation or resorption at either time points. …”
Get full text
Article -
2436
Intrinsic properties of dispersion-strengthened HfO2–Al2O3–SiO2 material as an EBC bond coat
Published 2025-05-01“…The dispersion-strengthened structure with a microstructure of oxides (HfO2 and Al2O3) dispersed in silicates (mullite and HfSiO4) can be achieved by systematically adjusting the component molar ratios, synthesis temperature, and time. …”
Get full text
Article -
2437
Behavior of compounds on the corrosion of ZK61-xCe magnesium alloys
Published 2025-01-01“…The role of compound on the corrosion of the alloy was analyzed based on changes in the microstructure, electrode potentials of compounds and matrix, and electrochemical properties of the corrosion product film. …”
Get full text
Article -
2438
Impact of voxel size on microCT morphometric analysis of the pumpkin toadlet
Published 2021-04-01“…X-ray microcomputed tomography is a nondestructive imaging technique which allows the visualization and analysis of internal microstructures of various samples, and has been applied on the study of these animals, enabling thorough description and characterization of new species. …”
Get full text
Article -
2439
Application of advanced diffusion MRI based tractometry of the visual pathway in glaucoma: a systematic review
Published 2025-05-01“…One such technique is tractometry, which quantifies white matter (WM) microstructural properties. While the application of tractometry in glaucomatous patients is developing, several key studies have explored structural changes in the brain, particularly within the visual pathways, in individuals with glaucoma. …”
Get full text
Article -
2440
Effect of Chinese Leek Extracts on the Quality of Sauce Stewed Pigeon Meat
Published 2025-07-01“…The changes in output rate, quality characteristics, sensory characteristics, and microstructure of sauce stewed pigeon meat were comprehensively evaluated. …”
Get full text
Article