-
41
Construction and Study of Hetreojunction Solar Cell Based on Dodecylbenzene Sulfonic Acid-Doped Polyaniline/n-Si
Published 2012-01-01“…The photovoltaic cell parameters, that is, open-circuit voltage (𝑉oc), short-circuit current density (𝐽sc), fill factor (FF), and energy conversion efficiency (η) were calculated. The highest 𝐽sc, 𝑉oc, and efficiency of these heterojunctions obtained using PANI-DBSA as a window layer (wideband gap) and Au as front contact are 1.8 mA/cm2, 0.436 V, and 0.13%, respectively. …”
Get full text
Article -
42
Fabrication and evaluation of a CMOS-based energy harvesting chip integrating photovoltaic and thermoelectric energy harvesters
Published 2024-10-01“…The EHC integrates a thermoelectric energy harvester (TEH) and a photovoltaic energy harvester (PEH) to maximize energy conversion efficiency. A key challenge in TEH design is enhancing power output, which is addressed by suspending the cold ends of 41 thermocouples within the TEH structure through post-processing. …”
Get full text
Article -
43
An Investigation of Energy Consumption Characteristics of the Pump-Control System for Electric Excavator Arms
Published 2024-11-01“…The influence of energy conversion efficiency and the speed between the motor and the hydraulic pump under varying load-power conditions has been determined through experimental investigations. …”
Get full text
Article -
44
Advanced Wastewater Treatment: Synergistic Integration of Reverse Electrodialysis with Electrochemical Degradation Driven by Low-Grade Heat
Published 2024-10-01“…Then, this review examines the impact of several key operational parameters, degradation circulation modes, and multi-stage series systems on wastewater degradation performance and energy conversion efficiency in RED reactors. The analysis highlights the economic feasibility of using SGE derived from low-grade heat to power RED technology for wastewater treatment, offering the dual benefits of waste heat recovery and effective wastewater processing.…”
Get full text
Article -
45
Maximizing Output Power of a Solar Panel via Combination of Sun Tracking and Maximum Power Point Tracking by Fuzzy Controllers
Published 2010-01-01“…In applications with low-energy conversion efficiency, maximizing the output power improves the efficiency. …”
Get full text
Article -
46
The State of the Art: Application of Green Technology in Sustainable Pavement
Published 2018-01-01“…Fundamental mechanics of energy harvesting techniques and possible designs of energy harvesters are described, with the evaluation of energy conversion efficiency, and advantages and disadvantages. …”
Get full text
Article -
47
Electro-spun nanofibers-based triboelectric nanogenerators in wearable electronics: status and perspectives
Published 2025-01-01“…Efforts towards improving energy conversion efficiency, material durability, and compatibility with diverse wearable platforms were visited. …”
Get full text
Article -
48
Design and Optimization of Multilevel Inverters for Enhanced Power Quality in Renewable Energy Applications
Published 2024-01-01“…By employing advanced control techniques and optimal switching strategies, the proposed inverter design minimizes harmonic content and improves energy conversion efficiency. Simulation results demonstrate the effectiveness of the multilevel inverter in renewable energy applications, contributing to more stable and reliable power delivery.…”
Get full text
Article -
49
Review on Maximum Power Point Tracking Control Strategy Algorithms for Offshore Floating Photovoltaic Systems
Published 2024-11-01“…Floating photovoltaic systems are rapidly gaining popularity due to their advantages in conserving land resources and their high energy conversion efficiency, making them a promising option for photovoltaic power generation. …”
Get full text
Article -
50
The thermoelectric conversion efficiency problem: Insights from the electron gas thermodynamics close to a phase transition
Published 2025-02-01“…The bottleneck in modern thermoelectric power generation and cooling is the low energy conversion efficiency of thermoelectric materials. The detrimental effects of lattice phonons on performance can be mitigated, but achieving a high thermoelectric power factor remains a major problem because the Seebeck coefficient and electrical conductivity cannot be jointly increased. …”
Get full text
Article -
51
Impedance Reshaping Strategy for Battery Energy Storage Systems Based on Partial Power Conversion
Published 2025-01-01“…To avoid additional component losses while significantly improving the energy conversion efficiency of battery energy storage systems, the application of series-connected partial power converter (S-PPC) technology in battery energy storage systems is investigated in this study. …”
Get full text
Article -
52
Molecular study and analysis of organic compounds for high-performance solar cell applications
Published 2025-01-01“…In the initial section, we evaluated the energy conversion efficiency of compounds, with performances between 7% to 11%. …”
Get full text
Article -
53
Intraband transitions at a CsPbBr3/GaAs heterointerface in a two-step photon upconversion solar cell
Published 2024-11-01“…Such a solar cell can ideally achieve an energy conversion efficiency of 48.5% under 1-sun illumination. …”
Get full text
Article -
54
Enhanced antireflection and absorption in thin film GaAs solar cells using dielectric composite nanostructures
Published 2024-12-01“…This study investigates the application of dielectric composite nanostructures (DCNs) to enhance both antireflection and absorption properties in thin film GaAs solar cells, which are crucial for reducing production costs and improving energy conversion efficiency in photovoltaic devices. Building upon previous experimental validations, this work systematically explores the underlying theoretical mechanisms using the finite difference time domain (FDTD) method to analyze the light interaction with the proposed DCNs. …”
Get full text
Article -
55
Morphological Effect of CNT/TiO2 Nanocomposite Photoelectrodes Dye-Sensitized Solar Cell on Photovoltaic Performance with Various Annealing Temperatures
Published 2015-01-01“…The thin films annealed at 750°C had the highest energy conversion efficiency at 5.23%. The EIS analysis estimated the values of the effective electron lifetime (τeff), effective electron diffusion coefficient, effective electron diffusion (Ln), and effective recombination rate constant (keff). …”
Get full text
Article -
56
Synthesis of nanostructured semiconducting cerium oxide associated titanium dioxide as photoanodic material for dye sensitized solar cells
Published 2025-06-01“…With an effective energy conversion efficiency of roughly 3.5 %, the measured short-circuit current density (Jsc) and open-circuit voltage (Voc) were 9.0 mAcm−2 and 680 mV, respectively. …”
Get full text
Article -
57
High-flux angularly uniform proton beams from multiple laser interaction with wire-hemisphere targets
Published 2024-01-01“…A scheme for generating high-flux angularly uniform proton beams with high laser-to-proton energy conversion efficiency is proposed. Three laser beams are focused on a microwire array attached to a solid-density hemispheric target. …”
Get full text
Article -
58
Characterization of Wind Turbine Blade Deformation and Wake Flow Field with Different Numbers of Lay-Up Layers
Published 2024-11-01“…A reasonable lay-up scheme can improve the deformation and stress of the blade, extend the service life of the blade, promote airflow mixing, and enhance the energy conversion efficiency.…”
Get full text
Article -
59
Optimal scheduling of integrated energy system for hydrogen production with electricity
Published 2024-12-01“…This study presents a strategy for the IES, whose goal is to reduce the carbon content of the power system, which aims to constrain the carbon emission of IES further, improve energy conversion efficiency, and reduce the carbon content of IES. …”
Get full text
Article -
60
Design of Incremental Conductance Sliding Mode MPPT Control Applied by Integrated Photovoltaic and Proton Exchange Membrane Fuel Cell System under Various Operating Conditions for...
Published 2015-01-01“…Under changing atmospheric conditions, the energy conversion efficiency of a PV array is very low, leading to significant power losses. …”
Get full text
Article
