-
1
-
2
Fabrication of ZnO Nanowire Cold Cathode Flat-Panel X-ray Source with a Reflective Anode
Published 2024-09-01Subjects: Get full text
Article -
3
-
4
Design of a miniaturized terahertz traveling wave tube with embedded single-walled carbon nanotubes cold cathode
Published 2025-05-01Subjects: Get full text
Article -
5
The CaO Enhanced Defluorination and Air-Jet Separation of Cathode-Active Material Coating for Direct Recycling Li-Ion Battery Electrodes
Published 2024-12-01Subjects: Get full text
Article -
6
Experimental Investigation of Cold Fusion Phenomena in Palladium
Published 1989-09-01“… We conducted at the Paul Scherrer Institute a series of Pd-D2O electrolysis experiments to investigate the existence of the «cold fusion» phenomenon. In a D2O-test cell and a H2O-reference cell, a search for excess heat was made, using a closed-circuit calorimetry set-up, and running currents onto 1 mm and 2 mm palladium cathode wires from 120 to 545 mA/cm2. …”
Get full text
Article -
7
NANOSTRUCTURED CARBON MATERIALS IN EMISSION ELECTRONICS
Published 2017-06-01Subjects: Get full text
Article -
8
-
9
Changer in the texture orientation of electrolytic nickel by cold air plasma
Published 2020-01-01“…The effects of cold air plasma influence on the change in the microstructure, stress state and texture of the cathode nickel brand H-1 were studied. …”
Get full text
Article -
10
Evaluation of Evaporative Degradation of Arc Torch Cathodes in Hydrocarbon-Containing Plasmas for Spraying, Thermal Protection Testing and Related Technologies
Published 2022-06-01“…We theoretically estimated the evaporative degradation of the material for three variants of EAPT cathode with alkane-containing plasmas (“hot” thermochemical zirconium and thermionic tungsten, and “cold” copper) in equilibrium and quasi-equilibrium modes of “plasma gas + surface cathode material”-mixture, with use of generalized thermodynamic properties of the materials. …”
Get full text
Article -
11
High-performance Na3V2(PO4)3/C cathode for efficient low-temperature lithium-ion batteries
Published 2025-03-01“…Abstract Existing cathode electrode materials used in commercially available lithium-ion batteries (LIBs) exhibit inadequate electrochemical performance at low temperatures, significantly constraining their utility in regions with cold climates. …”
Get full text
Article -
12
Low-temperature carburizing improves hydrogen embrittlement resistance of cold worked 304 austenitic stainless steel
Published 2025-05-01“…In this study, low-temperature carburizing (LTC) was performed on cold worked 304 ASS. Its effect on the mechanical properties and HE was investigated by electrochemical cathodic hydrogen charging and slow strain rate tensile test. …”
Get full text
Article -
13
Оptimization of the chrome plating bath operation during the restoration of vehicle parts
Published 2021-09-01“…When conducting studies of the obtained cold self-regulating chromium plating electrolyte, it was found that trivalent chromium has a significant effect on the stability of the chromium plating bath. …”
Get full text
Article -
14
Corrosion inhibition performance of rapeseed cake meal extract on cold-rolled steel in monochloroacetic acid: Adsorption characteristics and mechanism study
Published 2025-09-01“…The view of the corrosion protection of cold rolled steel (CRS) in monochloroacetic acid (ClCH₂COOH) medium, a green corrosion inhibition strategy using rapeseed cake meal as raw material is proposed in this work. …”
Get full text
Article -
15
Effect of cold rolling rates on microstructure and corrosion behavior of selective laser melted 316L austenitic stainless steel bipolar plates
Published 2025-03-01“…The effect of varying cold rolling deformation rates on the microstructure and corrosion behavior of selective laser melted (SLMed) 316L austenitic stainless steel (ASS) was investigated using electron backscattered diffraction and electrochemical tests. …”
Get full text
Article -
16
Corrosion Inhibition of Anionic Surfactant on Steel in Trichloroacetic Acid Medium
Published 2021-08-01“…Results showed that SDS could effectively retard the corrosion of cold rolled steel in 0.10 mol/L Cl3CCOOH solution, and the inhibition efficiency increased with the increase of SDS concentration. …”
Get full text
Article -
17
Study on the Influence of Ca<sup>2+ </sup>and Mg<sup>2+</sup> on the Properties of Zinc-Manganese Phosphate Coatings
Published 2025-05-01“…With the increasing environmental requirements, the zinc manganese nickel ternary phosphating process is strictly restricted due to nickel pollution, therefore, nickel-free phosphating technology for cathodic electrophoresis is receiving attention.In this study, Ca2+and Mg2+were used instead of Ni2+, and the effects of Ca2+and Mg2+on the microstructure, film weight and dissolution rate of the phosphating film formed on cold-rolled plates were analyzed by XRD, SEM and other methods.The matching performance of the phosphating film with cathodic electrophoresis was also tested.It was shown that the grain size was refined by Ca2+, the film thickness was increased by Mg2+, and the resistance of the phosphating film to electrophoretic-paint dissolution was improved by the combined addition of Ca2+and Mg2+.The new zinc-manganese phosphating solution with added calcium and magnesium ions was found to have stable and controllable ion concentrations.After phosphating electrophoresis, the resulting coating was able to withstand a neutral salt-spray test for 800 h and met the requirement for cathodic electrophoretic coatings of a single-sided extension of 2 mm or less.…”
Get full text
Article -
18
Investigation on microstructure and corrosion behavior of selective laser melted 316L stainless steel at various high-speed deformation levels
Published 2025-09-01“…This study examines the impact of high-speed cold rolling deformation on the microstructure and corrosion resistance of selectively laser melted (SLMed) 316L stainless steel after solution treatment at 1100 °C for 0.25 h in a simulated proton exchange membrane fuel cell (PEMFC) cathode environment. …”
Get full text
Article -
19
Commentaire: Pourquoi les Expériences de «Fusion Froide» de Deutérium Sont-elles Si Difficiles à Reproduire?
Published 1989-04-01“… The particular conditions of the experiments described by Fleischmann and Pons, relative to “cold nuclear fusion” are examined. The possible role played by the platinum anode and the alkaline LiOD solution is discussed. …”
Get full text
Article -
20
On a Search for Hidden Photon CDM by a Multicathode Counter
Published 2016-01-01“…We report a new technique of a multicathode counter (MCC) developed to search for hidden photon (HP) cold dark matter (CDM) with a mass from 5 to 500 eV. …”
Get full text
Article