Hot Deformation Behavior and Optimization of Processing Parameters for 4Cr16MoCu Martensitic Stainless Steel
The hot deformation behavior of 4Cr16MoCu martensitic stainless steel alloyed with 1% Cu was investigated through hot compression tests at temperatures ranging from 900 to 1150 °C and strain rates of 0.001 to 1 s<sup>−1</sup>. The addition of Cu is strategically employed to synergistical...
Saved in:
| Main Authors: | , , , , |
|---|---|
| Format: | Article |
| Language: | English |
| Published: |
MDPI AG
2025-03-01
|
| Series: | Metals |
| Subjects: | |
| Online Access: | https://www.mdpi.com/2075-4701/15/4/373 |
| Tags: |
Add Tag
No Tags, Be the first to tag this record!
|
| Summary: | The hot deformation behavior of 4Cr16MoCu martensitic stainless steel alloyed with 1% Cu was investigated through hot compression tests at temperatures ranging from 900 to 1150 °C and strain rates of 0.001 to 1 s<sup>−1</sup>. The addition of Cu is strategically employed to synergistically enhance precipitation hardening and corrosion resistance, yet its complex interplay with hot deformation mechanisms remains poorly understood, demanding systematic investigation. The results revealed a narrow forging temperature range and significant strain rate sensitivity, with deformation resistance increasing markedly at higher strain rates. An Arrhenius constitutive model incorporating a seventh-degree polynomial for strain compensation was developed to describe the flow stress dependence on deformation temperature and strain rate. The model demonstrated high accuracy, with a correlation coefficient (R<sup>2</sup>) of 0.9917 and an average absolute relative error (AARE) of 3.8%, providing a reliable theoretical foundation for practical production applications. Furthermore, a hot processing map was constructed based on the dynamic material model (DMM), and the optimal hot working parameters were determined through microstructural analysis: an initial forging temperature of 1125 °C, a final forging temperature of 980 °C, and a strain rate of 0.1 s<sup>−1</sup>. These conditions resulted in a fine and uniform grain structure, while strain rates above 0.18 s<sup>−1</sup> were identified as unfavorable due to the risk of uneven deformation. |
|---|---|
| ISSN: | 2075-4701 |