To Calculation of Fillet Welds
When making welded joints, it is not always possible to press tightly elements to be joined before surfacing the weld. In normative documents on welded joints, the allowable gap between the elements to be connected can reach 3 mm when welding with a covered electrode and 2 mm when welding in shield...
Saved in:
| Main Authors: | , |
|---|---|
| Format: | Article |
| Language: | Russian |
| Published: |
Belarusian National Technical University
2020-10-01
|
| Series: | Наука и техника |
| Subjects: | |
| Online Access: | https://sat.bntu.by/jour/article/view/2357 |
| Tags: |
Add Tag
No Tags, Be the first to tag this record!
|
| Summary: | When making welded joints, it is not always possible to press tightly elements to be joined before surfacing the weld. In normative documents on welded joints, the allowable gap between the elements to be connected can reach 3 mm when welding with a covered electrode and 2 mm when welding in shielded gases. At the same time the presence of a gap is not taken into account in the standards for calculation of welded joints. Experimental studies have been carried out to determine effect of the gap on the bearing capacity of the weld. Specimens have been made with welded joints of two types: for work in shear and pull-out. For the purpose of comparison, half of the specimens have been made without gaps, and the other half with gaps between the elements to be joined. The specimens have been made at the Minsk plant of technological metal structures, and their tests have been carried out in a research laboratory of the Belarusian National Technical University. Based on the results of the experiments, it has been concluded that the gaps between the elements to be joined significantly reduce the bearing capacity of the welded joints. In addition, inspection of fracture surfaces have shown that, in the presence of a gap, the cut surfaces of the weld pass along the fusion boundary of the base and deposited metals. It has been experimenttally established that the existing gap leads to a slight increase in the penetration depth. However, the latter factor does not compensate for the decrease in the bearing capacity of the welded joint due to the presence of a gap between the elements to be joined. |
|---|---|
| ISSN: | 2227-1031 2414-0392 |